Open Web Rx >NetSDR via Soapy on a Pi4 andrus sdr mk1.5


Daniel Young
 

Having recently purchased an andrus MK1.5 sdr that is in transit it, supports NetSDR, it isn't on the Web Rx supported hardware unsurprisingly as rare.
But the compatibility list soapy sdr mentioned and soapy sdr supports NetSDR.

My thinking was if I could run the pi4 and mk1. 5, POE away from local electrical noise perhaps and have a kiwisdr type setup. 

NetSDR Interface Specification Rev. 1.05 Sept 8, 2014 - MoeTronix
www.moetronix.com › files › NetS...

Any advice appreciated 

Thank you 


jdow
 

There are other forums where you might get a better answer than here. This forum is for a specific SDR software package available at sdr-radio.com.

{o.o}

On 20220201 17:27:40, Daniel Young wrote:

Having recently purchased an andrus MK1.5 sdr that is in transit it, supports NetSDR, it isn't on the Web Rx supported hardware unsurprisingly as rare.
But the compatibility list soapy sdr mentioned and soapy sdr supports NetSDR.

My thinking was if I could run the pi4 and mk1. 5, POE away from local electrical noise perhaps and have a kiwisdr type setup. 

NetSDR Interface Specification Rev. 1.05 Sept 8, 2014 - MoeTronix
www.moetronix.com › files › NetS...

Any advice appreciated 

Thank you