Date
1 - 3 of 3
SDR-Radio, IC-7300, HRD and WSJT-x
|
Brad Penn
Hello everyone,
I have a new Icom IC-7300 with the installed PTRX-7300 module to output via a SDR Play RSP1A to a larger monitor for panadapter use. My problem is that when using sdr-radio v3 along with HRD, and WSJT-x, I can't get WSJT-X to activate TX via the IC-7300 internal sound device. SDR-Radio controls the IC-7300 via OmniRig perfectly. I use 2 virtual ports per VSPE so SDR-Radio can talk to HRD. This combination of programs works perfectly when using SDR Uno. I just can't figure out why I can't get WSJT-X to activate TX via the internal sound device in the IC-7300 when SDR-Radio is used instead of SDR Uno. I have a Yaesu FT-950 that would work with both SDR-Radio and SDR Uno when using a Signalink USB soud card. Any suggestions out there. Any help would be greatly appreciated Brad KD5ZAT |
|
|
|
Andrew OBrien <k3ukandy@...>
Just out of curiosity, can you enable PTT of the 7300 if using any of the digital modes within DM780 ? Andy K3UK On Sun, May 31, 2020 at 8:40 PM Brad Penn <bjpenn1@...> wrote: Hello everyone, |
|
|
|
Brad Penn
Hi Andrew,
Good suggestion. I can't enable the PTT in DM780 with listed combination of programs. Like I said previously, I use 2 virtual ports to allow SDR Radio to talk to HRD. When connecting HRD via the virtual serial port to SDR-Radio I use the connect protocol of the Kenwood TS480. This is suggested by the folks at SDR Play. When I try to transmit with DM780 I get an error with the TS480 connection. I think I'll take a step back and ponder on this some more. Thanks again, Brad KD5ZAT |
|
|