Group:

I’m working through configuring SDR console v3 as a panadpater display for use with a K3. The configuration is as follows:

SDR Console v3.0.17

Win 10 pro Intel I7 gen 8

SDR-IQ

DXLab with Omni-Rig connected to the secondary com port of DXLab Commander using virtual com ports.

I’ve have run into a couple of issues that I have not been able to resolve:

1. When the K3 mode is set to Data A (USB) the SDR Console displays Data-L. Using DXLab Commander to change radio mode to Data=L, SDR Console displays Data-U
2. SDR Console will occasionally display the B VFO frequency of the K3, the radio is not in split. DX Commander and my amp both display VFO A properly
3. I’m unable to get the passband on the spectrum display to overlay the actual passband correctly. I suspect that this is related to #1.

This is a great application!

Any assistance is greatly apricated.

73

Gregg W6IZT

Group:

I was able to resolve # 1 and #3 by changing the protocol of the DXLab Commander Secondary port from K3 to Kenwood TS-590.

73 HH

Gregg W6IZT