Merge SDRC Favorites notes (Link to executable at the bottom.) This is for SDRC V3 through the current version as of 20190622. Merge SDRC Favorites is the only file in the zip file and may be stored o

Experiment. Since I don't know your specific circumstances I cannot offer any suggestions other than that most suggestions you find on the web are as far out as the Moon. What are your specific circum

That does not tell me your circumstances, only your use. While it helps a litle (rules out Radio Astronomy tweaks) it still does not suggest what is best for you. Presuming you are passing rational (a

It is setup to use unicode. I see some of the same funny characters. So it's probably a character set choice that causes it. I could try compiling a version for multi-byte character set if you're will

I'm not sure what those characters are supposed to be. It does not matter whether I compile with Unicode, "Multi-Byte", or "Not set". The characters come up "odd". It is probably related to the font t

The Preamplifier will cost you some dynamic range. An ADSB filter would be called for. The preamplifier gain should be "about" 3dB to 6dB more than the combined loss of any filters and coax which sit

That would be a deficiency with the drivers, methinks. __int64 is a valid, and simple, way to enable a very high upper limit on frequency. If Simon did that there would be no problem unless you tried

225000 sps {^_^}

While that would be nice I was rather hoping it would ship when it is 100% ready to ship. {o.o}

It occurs to me that the signal itself is low signal to noise ratio so the noise and the signal would rise together, as always, Of course, you could open the matrix and adjust that receiver's individu

Learning is a rewarding if painful process. Without it I am afraid helping you MAY not be possible. Explore and play with it. You have a ham license so you cannot be totally technically unaware. The m

Press alt-print screen with the window you want captured on top. Then past it into paint or equivalent, save it, and send it. {^_^}

That's another rtlsdr receiver. HF performance will be disappointing if you lack a moderately serious antenna. If you really REALLY want to try it and are willing to forget 10 meters, I have a "soluti

Basically you don't at present. You can use my "Merge SDR Favorites.exe" tool to at least show some of the tuning information - and merge data from identity to identity or save it off or import it. Go

In general you want to avoid straddling signals across the central spike. Offset it slightly so that does not happen. The central spike will leave a remnant present that is the self-conversion of the

I've wished for a zoom that will zoom around the active receiver rather than the center teet since V2 days. But as my Ulster-Scot grandfather observed, "If wishes were horses beggars would ride." Mayb

I believe I did say the performance at HF for the RTL dongles leaves something to be desired. It works with very limited dynamic range and depending on the mode used very poor sensitivity. For a dongl

On a hunch swap I and Q if you can. I'd expect low frequencies on the right side of the spectrum and high on the left contrary to normal. So that's an easy diagnosis. {^_^}

Heh, that is when I was using a better system than Mac or PC with out of this world potential, the Commododo Amiga. Unfortunately Irving Gould and Mehdi Ali decided to milk the stockholders and custom

First program I wrote was on an IBM 7090 at the University of Michigan using the "MAD" language. Seriously, MAD, Michigan Algorithm Decoder, was the language. It was all punch cards in 1963. I decided