Hello, Have been playing around with a new YouLoop passivesmall Loop Ant. Very weak signal, but noise is less, as was to be expected. Was wondering about using a decent quality pre-amp. Would the

Charles, What are your temperature readings when Console refuses to being closed? Brake out in USB cable is very easy. Red is positive and black negative. I built a 5.3VDC power supply with a 7805 and

Tanks for the reply Siegfried, it made a few more clear. This is what I like to set up: 1) N1mm or HRD communicates with the SDR console using virtual ports 10/11 which are set up by VSPE tool 2) SDR

bump

The same here .... Cordiales salutations de Denis FERRAND ---------- Forwarded message --------- De : Patrick <malfam2@...> Date: dim. 19 avr. 2020 à 18:24 Subject: Re: [SDR-Radio] Change default

Siegfried, Thank for your response. You were right! From the main screen, I clicked "Select Radio", then selected my SDR-RTL, and then I clicked "Definitions". After that, I checked "Converter

first loks good but maybe you have to invert spectrum in dream?? second has a way too low receive quality (and why there is half bw nearly missing??) in dream you have seeral optins on

And, I’ll get Dream working tomorrow morning and add info on my website. Simon Brown, G4ELI https://www.sdr-radio.com

Hi, What doesn’t make sense is that this only happens on one band, so I was wondering whether it could be a setting you have which is specific to 10M. Tomorrow I’ll show you how we can use

Simon... Thanks. I know you are busy, so I REALLY, REALLY thank you !! 1. Yes, 100ms 2. Yes, 38400 3. Yes, Eliminating rig control software, and manually punching the buttons on the Yaesu,

You need a lot of signal gain to decode DRM with Dream. Like in Dream's analyzer part, you want something like 16dbm or more and something like a solid S9 or greater as measured by SDRC. Idk about

Everything is the same as yesterday - including OmniRig settings- but today I am back to square one. When I did a system restore to last December everything worked. I cannot see anything different

Seconded, and I know there are a lot of other FDM-DUO users keen for this too! At the moment Simon has stated it isn't possible due to limitations of the Elad support library. Presumably we need to

there are TOW ways to connect to sdr console ... one is external radio (that is used to be sdr console the master and rig follows) one is using the cat commands from console (acting

yes ... in radio selection there is a (now white) box where you can add an offset (say you have a 120mhz local in your upmixer or a 50mhz local ... no idea what spyverter has as internal

So, Keep it cool, I always like my radios & computers to run cool. If you want I can send you a Lime Mini (latest flavour) for testing once the lockdown’s over as the effing local PO is closed

Hi, I managed to reproduce this once, anyway I’ve added an extra check to be sure the display behaves correctly. Simon Brown, G4ELI https://www.sdr-radio.com

Hi, https://www.sdr-radio.com/elad#FDMDUOr There is… Simon Brown, G4ELI https://www.sdr-radio.com

No, That’s really why I wrote it. I could add the option. Simon Brown, G4ELI https://www.sdr-radio.com

.Zoek op youtube naar "pa0nhc" . Of ga naar "www.pa0nhc.nl". Druk dan op F5. Zie tabel. 73's, Nico.