That is my intention. A good low power amp might be the QRP-Labs 10 watt linear amplifier. an easy build and very inexpensive. Along with their bandpass/lowpass filter kits. I was doing some reading

Try typing “netstat -a” on Command Prompt without the quotes and hit the Enter button. This will populate a list of your active TCP connections. The port numbers will be shown after the IP address

I did View, Band Plan, editor, selected entry to delete, click delete, click close. I exited from SDR Console and restarted it. When I went to Band Plan, the deleted entry was gone. I am running

Yes, I will ask for a membership there. I also asked for a membership in the openHPSDR reflector: http://openhpsdr.org/reflector.php but not yet got an approval there. Waiting.... 73 / Ingolf

I would ask the question on the Apache forum. I could not find any reference to the port number also. Conrad

Hi Conrad. Thanks for the link. Unfortunately, it seems that they are trying to do something different. I get the impression that they try to use some other SW to get the audio accessible remote. They

Same for me. I could'nt save changes made with the editor. This is why I modified the xml file according to my needs : no détails in the ham bands, more details outside BC and ham bands. 73 Michel

Hello Ingolf as I will not be doing any port forwarding, I did not read this in too much detail. You can maybe glean something from this thread.

OK, I have to go out today, will look into this later this evening. Has to be a setting somewhere. Simon Brown, G4ELI https://www.sdr-radio.com

disabeling of auto mute and NB didn't help too

Hi all. As I have put an order on this Hermes board I have started to read to learn more about this board. Reading the Hermes User Manual V1.18 I can not find any reference to a port number on the

Thanks Kriss, All great options, Thought i would mention 2 that I use: If you are ok with the Freq range (10 M or higher), then this is a great (and cheap $4.95 ) option from eBay. It is pin diode

I assume you want at least 1 KW out? I used a Herems 16 bit board with one of these to drive a HB 6M LDMOS amplifier for testing Pure Signal. I did a presentation at one of the conferences years ago

I have the ANAN 200D, VERY clean with Pure Signal on. But would rather not use a RM Italy Amplifier, if they even have one for <1/2 watt input. That's why I was asking. 😬 73 Kriss KA1GJU

If you want "clean" check out Pure Signal - part of PowerSDR and Thetis for OpenHPSDR. -- 73, Mike, N1JEZ "A closed mouth gathers no feet"

Any suggested PA's that will take 500mW up to something useful and be clean? Asking for a lot probably. lol 73 Kriss KA1GJU

That issue might only happen while using an external radio such as your Yaesu FT-991A. This idiosyncrasy does not happen while using an SDR locally or via a server. I've never used SDRC with a

The 80mm fan I referred to is a Noctua NF-A6x25 FLX, super quiet and highly recommended. Conrad

Yes, I agree, TAPR have a breakout board for the multipin connector, but it is tiny and fiddly. I will buy a Hammond extruded box that is deep enough to run some tails for the RF connectors and make a

I have two SMA connectors on an ANAN 10 which have simply split, so I will use a diecast box and ensure there’s no stress on any connector. Also the big connector at the rear is a total PAIN, using