That auto-center box is for "auto center on zoom". If you hover over that box, the tool-tip text says so. My SDRC does not do what yours is doing but I am running a test team version. There is a

In the Editor I've unchecked or deleted the ones that are unimportant to me as some caused overlaps. How do I save these changes? When I started SDRC today they all returned. Do I have to edit the

My config: RSP1A, RFHUP PAT board in 991A, SDR Console bandwidth set to 500 khz (and still can't get rid of those damn spurs) The receiver display always shows the tuned freq is centered regardless of

Hello Kriss Thanks for the information. I've accumulated several of those type of limiters, some bought some home-brew. I recently bought an "overdrive switch" from SV1AFN. This device

Thanks, Simon. Just ordered one myself and look forward to seeing what you can do with it. regards, Roy

Hi Simon I assume You included the picture just for reference? Since this cable uses RP-SMA connectors, just be sure to check whether HL2 uses normal SMA or RP-SMA before

I use these, but they have been out of stock for months, and price just went up: https://www.arraysolutions.com/surge-and-rf-protection/as-rxfep But here’s another

Hello Kris What type of front-end protector are you using? 73s Tracey G5VU

In the original hammond box the connectors are supported by the back panel nuts, I never had any issues with this. There again I did not plug and unplug very often. Maybe you are right, might be

Hello Simon the original case is a Hammond 1455Q1601, which may be found here: https://www.digikey.nl/en/products/detail/hammond-manufacturing/1455Q1601/1995453 I am sure that we can get

Also, The SMA connectors soldered to the PCB are a weak link, so I’ll probably mount the unit in a diecast box and use these: Simon Brown, G4ELI https://www.sdr-radio.com

Also, I actually have 1 x ANAN 10 and 1 x ANAN 10E which I used for a few years on 80m and 40m. What I don’t like is the lack of good cooling, so I’ll probably take the 10E out of the case,

There's some good info (if somewhat dated) in this post by the Apache Labs forum administrator: https://apache-labs.com/community/viewtopic.php?p=18161#p18009 As I mentioned earlier, the latest

If you operate nearby, either get a receiver front end protector or install a relay to disconnect antenna during TX or when personal rig is powered up. I use both methods or non at all if there is

Thanks Kriss! This is something I need to get around to doing. So far I haven't found a 'round 2 it' of time yet. When I'm ready, I will reread your little mini-lesson. Dave Aichelman N7NZH

Well, An enclosure would be great. Was thinking about buying a small milling machine … Simon Brown, G4ELI https://www.sdr-radio.com

Nice work, Kriss! Thank you.

Here's a 'new' version of "How to make an SDRC Server"... a step by step, with images procedure. If the images are not here, go to the web gui and read/see them there! 1) A computer that will be

Yes, I ordered one and yes, I will be using it with transverters. Glad that Simon will look at SDRC/ANAN, this will be the first time that I have used SDRC on TX. As there are a few of us can we

On Thu, Feb 17, 2022 at 05:02 PM, Simon Brown wrote: I’ve ordered one, I expect SDR Console supports this but to be honest the Hermes / ANAN support does need TLC, so here’s a good reason to