On Tue, Feb 22, 2022 at 11:18 AM, Simon Brown wrote: Re: Audio, Use a decent microphone such as the Sennheiser 835, these are cheaper than HEIL. Use a good compander & limiter – as in SDR

Hi Folks, did now a no antenna test like jdow suggested. But first of all, if I switch the AGC to on the SDR RX went quiet and no spectrum/waterfall is displayed. So

Hallo jdow, many thanks for your detailed answer! Now I have a lot to do. One hand: really to understand all your suggestions because my english could be

Re: Audio, Use a decent microphone such as the Sennheiser 835, these are cheaper than HEIL. Use a good compander & limiter – as in SDR Console. On VHF with Sennheiser / FDM DUO / Q5 Signal I

Hello Max, in many ways I agree with you. Particularly on HF. I will not be running Pure signal but I will only use my Hermes with transverters on bands that have a very low noise floor. As Simon says

Simon regarding the IC7300. There is a very nasty noise bump at 130kHz out, this gets quite bad at reduced power, which is typically what happens when driving a PA. Look at the difference in the

On Tue, Feb 22, 2022 at 07:06 AM, Simon Brown wrote: Although Pure Signal can clean up a poor PA you should aim for a clean signal without resorting to Pure Signal – the IC-7300 is spectacularly

Tom, Re: boards – the Hermes card itself is clean without Pure Signal, in fact the 10E had a very clean output at 10W. Although Pure Signal can clean up a poor PA you should aim for a clean

Simon – Coffee is my friend all day long 😊 The K-cup machine here gets a work out….Peet’s Major Dickenson’s Blend is on auto replenishment monthly. I think I’m going to reserve the

Coffee is my best friend in the morning. Simon Brown, G4ELI https://www.sdr-radio.com

These are fine for aluminium / diecast. Quite a few to choose from. Simon Brown, G4ELI https://www.sdr-radio.com

Well, I’ll be on 4m and 6m this summer – mainly 4m but 6m during the 6m contests. I also will be on 2m but 2021 wasn’t so good – only 5 days with decent E’s for SSB. Full legal+ on

Thank you so much for doing this. Something I have been wishing for a long time after using sdr# and kiwi deep

See the following: https://sdr-radio.groups.io/g/main/message/65720 73 Kriss KA1GJU

Actually thin. Maybe I need to take up coffee. {O,o} On 20220221 14:33:53, jdow wrote:

There is a mute setting. Overload usually means you are transmitting. This prevents feedback. In your case the antenna switch made sufficient signal level change that it looked like you

Er thick not think. Just got up. {O.O} On 20220221 05:10:24, Simon Brown wrote:

Perhaps designed for wood and not think alumin(i)um. {O.O} On 20220221 05:10:24, Simon Brown wrote:

I think that you are right to do this, I am going to do the same. I will run mine at 0dBm to match both my K3S and TS-890 transverter drive levels when using it with uwave transverters. Its other job

Thanks. Conrad