OK Simon thanks. I am sure that you realised that I am just (im)patiently waiting for hardware and getting bored. Conrad

Never attribute to malice what you can attribute to ignorance and/or stupidity. "Maybe I'll get better reception if I turn everything up real high" might be one example (although I admit it's not

french press ..yepp thats good :-) dg9bfc sigi Am 22.02.2022 um 07:58 schrieb TOM - K2TC:

If you had an Anan you could see the difference graphically with the two tone test. Depending on the amp it can be quite dramatic. Bob - wd6dod On 2/22/2022 1:08 AM, Max

Denoiser, exists. Simon Brown, G4ELI https://www.sdr-radio.com

I was looking at the TX audio section, which I have not used yet. I cannot see a noise gate or downward expander, perhaps I missed it. If it is not present is there any possibility of adding one?

Pure signal... because of 'amateurs' like this who are 18kHz wide at a distance of 1197 miles away: I'm sure the folks on the Intercon Net on 14.300 were happy. 🙄 Try the attached movie for the

On Tue, Feb 22, 2022 at 11:18 AM, Simon Brown wrote: Re: Audio, Use a decent microphone such as the Sennheiser 835, these are cheaper than HEIL. Use a good compander & limiter – as in SDR

Hi Folks, did now a no antenna test like jdow suggested. But first of all, if I switch the AGC to on the SDR RX went quiet and no spectrum/waterfall is displayed. So

Hallo jdow, many thanks for your detailed answer! Now I have a lot to do. One hand: really to understand all your suggestions because my english could be

Re: Audio, Use a decent microphone such as the Sennheiser 835, these are cheaper than HEIL. Use a good compander & limiter – as in SDR Console. On VHF with Sennheiser / FDM DUO / Q5 Signal I

Hello Max, in many ways I agree with you. Particularly on HF. I will not be running Pure signal but I will only use my Hermes with transverters on bands that have a very low noise floor. As Simon says

Simon regarding the IC7300. There is a very nasty noise bump at 130kHz out, this gets quite bad at reduced power, which is typically what happens when driving a PA. Look at the difference in the

On Tue, Feb 22, 2022 at 07:06 AM, Simon Brown wrote: Although Pure Signal can clean up a poor PA you should aim for a clean signal without resorting to Pure Signal – the IC-7300 is spectacularly

Tom, Re: boards – the Hermes card itself is clean without Pure Signal, in fact the 10E had a very clean output at 10W. Although Pure Signal can clean up a poor PA you should aim for a clean

Simon – Coffee is my friend all day long 😊 The K-cup machine here gets a work out….Peet’s Major Dickenson’s Blend is on auto replenishment monthly. I think I’m going to reserve the

Coffee is my best friend in the morning. Simon Brown, G4ELI https://www.sdr-radio.com

These are fine for aluminium / diecast. Quite a few to choose from. Simon Brown, G4ELI https://www.sdr-radio.com

Well, I’ll be on 4m and 6m this summer – mainly 4m but 6m during the 6m contests. I also will be on 2m but 2021 wasn’t so good – only 5 days with decent E’s for SSB. Full legal+ on

Thank you so much for doing this. Something I have been wishing for a long time after using sdr# and kiwi deep