Yes, Then add PS. Simon Brown, G4ELI https://www.sdr-radio.com

Simon, I agree. Good modulator, filtering, clock and RF design and use of quality parts can eliminate the need for after the fact PS cleaning. A cost benefit analysis would show which method is most

FWIW I have never seen bad splatter from an IC 7300. I couldn’t care less about lab measurements, it’s what I see on the sir. Simon Brown, G4ELI https://www.sdr-radio.com

Hello Simon. Yuk! That is indeed awful. I will ask OT4A what he is using, I seem to remember that I have had problems with him on 6m from time to time. I am sorry but I really must take

Conrad, Watch: https://www.youtube.com/watch?v=NaGPZzGDKeU OT4A’s signal has got worse since this. I think he has a big OM Power amp but am not sure. The IC-7300 close-in signal is superb.

If there are enough excellent signals then maybe slowly the culture will change. When the manufacturers move on to a clean TX being the marketing differentiator then I am sure it will improve. Why is

Mark, What your description below shows is a very poor PA somewhere in your chain. I agree that PS can clean this up and indeed should be used, but for myself the first step would be to generate

OK, Now I have time to think about this. Let’s see the firmware you have installed: Click the Options link in the Radio window, select the Firmware tab, show me this. My current firmware is

On Tue, Feb 22, 2022 at 01:08 AM, Max wrote: Never quite sure what the obsession is with Pure Signal?MaxI'd like to try and answer that, at least to the degree that I own and operate an ANAN

That sounds VERY much like auto-mute is turned on. {^_^} On 20220222 06:18:55, Kurt Hechler wrote:

tools menu->options Click on "Auto-mute" on the left. On the right make sure "Enable" is not checked. The auto-mute function is on the lower right and is worth reading.

OK Simon thanks. I am sure that you realised that I am just (im)patiently waiting for hardware and getting bored. Conrad

Never attribute to malice what you can attribute to ignorance and/or stupidity. "Maybe I'll get better reception if I turn everything up real high" might be one example (although I admit it's not

french press ..yepp thats good :-) dg9bfc sigi Am 22.02.2022 um 07:58 schrieb TOM - K2TC:

If you had an Anan you could see the difference graphically with the two tone test. Depending on the amp it can be quite dramatic. Bob - wd6dod On 2/22/2022 1:08 AM, Max

Denoiser, exists. Simon Brown, G4ELI https://www.sdr-radio.com

I was looking at the TX audio section, which I have not used yet. I cannot see a noise gate or downward expander, perhaps I missed it. If it is not present is there any possibility of adding one?

Pure signal... because of 'amateurs' like this who are 18kHz wide at a distance of 1197 miles away: I'm sure the folks on the Intercon Net on 14.300 were happy. 🙄 Try the attached movie for the

On Tue, Feb 22, 2022 at 11:18 AM, Simon Brown wrote: Re: Audio, Use a decent microphone such as the Sennheiser 835, these are cheaper than HEIL. Use a good compander & limiter – as in SDR

Hi Folks, did now a no antenna test like jdow suggested. But first of all, if I switch the AGC to on the SDR RX went quiet and no spectrum/waterfall is displayed. So