Thanks for the insights, Dave. Following your advice, I placed some clamp-on ferrites onto the extension cord and moved them to various positions along the length of the cord. The RFI hash never

Hi, I would put a high Z, ferrite suppression choke on the extension cord at the plug end as a test. If the RFI goes away or is reduced, then as you suggested, the cord is probably a transmitting

Greetings all, I stumbled upon an interesting/surprising “source” of RF interference in my SDR listening. I’m using an Airspy HF+ discovery connected through 75-ohm coax to a ~60-foot

I'm using a remote setup with RCForb client to connect to the remote RCForb server running a TS-590sg radio. I have an RSP1a SDR hooked up to the DVR (rx output port) with the SDR Commander server

Ok you mean a converter definition in the SDR definition itself.. I will try it… As I‘m working with different identities in SDR Console this could be a perfect solution.. 73 Attila DC0ED

No.. I mean when you start the sdr.. Start with converter offset. Not the icom... The sdr!! Dg9bfc sigi Am 30.12.2021 19:48 schrieb "Attila Baloglu via groups.io" <dc0ed@...>:

Dear Sigi,  you mean setting the offset in the Icom IC9700? I will try it, maybe a workaround until it works in SDR Console.. I‘m a bit curious about the tracking with the offset in the TRX, but

Sorry for typos... Am 30.12.2021 19:30 schrieb Siegfried.Jackstien@...:

Converter in radui definitions could be used. Set the needed offset for 23cm band. Start radio with that offset. On 2m and 70cm the offset is not used (ignored) while on 23cm it is used. Works

Hi, I did not know about this problem, maybe in 2022. Simon Brown, G4ELI https://www.sdr-radio.com

Hi Sigi, my receiving is done above the sdr frequency, the converter works only additive… In SDR Console it should look like this with tracking the IC9700 and the RSP2pro sdr must be on

Hmm.. In radio definitions the converter?!? That should do it On qo100 we have a display of 10 gig... But receiving is done on 740 megs Similar as your offset I do not use an icom but i guess the

Hello Group, I'm using a Icom IC9700 with build in PTRX-9700 Panorama Adapter connected to SDRplay RSP2pro with SDR Console. The PTRX-9700 output on 2m / 70cm and the IC9700 receive Frequency are the

It could well be the PSU, more chance of caps blowing than the CPU needing new grease. Simon Brown, G4ELI https://www.sdr-radio.com

And you know my money is on the power supply. I guess it will be the great unanswered question of 2021. Happy New Year Simon and thanks for your hard work. -- Dennis KA6FUB

I bet it was the CPU temperature… Simon Brown, G4ELI https://www.sdr-radio.com

That's good news. Happy New Year... -- Dennis KA6FUB

Hi guys, My aging 420W Zalman PSU was replaced with a brand new 650W Corsair PSU. Thermal grease also replaced on the CPU. Launching SDR Console doesn't shut off the PC anymore! Thank you all for

Hi Max. CHT is audible here right now, December 28, 2159 UTC. QRB 1029 km. I am using a AFEDRI Net and a 80 m terminated Beverage antenna beaming in 250 degrees. It is NOT audible on the 135 m