So how does one make this happen? Last week my issues was I was running the wrong version of Omni Rig the corect one is 1.20 which is what I am running. Thanks again but there has to be a solution

virtual comport may be a shared port .. one end to sdrc ... other end to omnirig dg9bfc sigi Am 05.07.2022 um 22:29 schrieb jdow:

I am thinking in terms of communications between OmniRig and SDRC. Remember that you cannot open a com port and share it with multiple applications. So you cannot connect SDRC to the radio's

I echo your observations, Paul. I have found EXACTLY what you describe. Larry

RDS decoding in Console is very good but always check reception a few times from recordings, I've lost count of the times I've played back a short section of reception and the PI code has popped up

jdow thanks for the quick reply. My radio is using com 7, Yaesu installs two com ports one for rig control, in my case com 7 and com 8 sends data cw digital ect. So how can I use a virtual cable?

With com0com or equivalent you get virtual cables that have two ends. If you try to open COM7 in SDRC and in OmniRig it's not going to work. Find the other end of COM7's virtual cable and

SDRC is not designed to support side-by-side installations. A proper such design would not use the same registry and %apdata% folders for storing settings, thus making them truly independent

Sorry I thought I added this photo. When I try to open the external radio here what I get: -- Thanks you

When I set up Omni Rig I am using the comport assigned to my radio "Com 7" -- Thank you

I found the problem. The command 'Buffers' has been replace with 'BufferParts'. Any existing batch files need to be edited with this change. Audio using SDR Console now sounds good.

Control Panel picture attached

Last night, I updated VAC from 4.15 to 4.67. When I use my batch files (one file per VAC Line) to start Audio Repeater, I receive the error message as shown in an attached picture. This picture shows

Max I can't seem to find how to attach my photos. When I try to open the external radio it's looking for Omni Rig,that's SDRC contacts to my radio. -- Thanks Cody

I looked at that one - it says "multimedia" so I wasn't sure. I found this one and also found out SDRConsole supports mapping keys to the functions - this one has programmable keys. For example, I

Maybe it does help setting the cables to a fixed 48 k sampling speed?!? (just a shoot in the dark) DG9BFC sigi Am 05.07.2022 10:11 schrieb "George Stein - NJ3H via groups.io" <nj3h@...>:

Yes, the maximum cache size is 480MB, I'll increase this to the greater of 480MB and 1/8 installed RAM, so if you have 8GB it'll be 1GB, if you have 16GB it'll be 2GB etc. Simon

Hi Simon, Thanks for looking at this issue. Would you be so kind to annotate on the VAC Control Panel picture which field or fields need updating and what a good value would be? Have a good Tuesday.

Thanks, it's flow control bursting. If possible, put a bigger buffer in the VAC I think. Simon Brown https://g4eli.com https://sdr-radio.com

On Tue, Jul 5, 2022 at 01:33 AM, Cody wrote: I had everyhtnig working well . Now when I try to run my external radio I get the Omni Rig fault. I using Omni 1.2