Yes Max, I followed that page. I attached the screenshot with the home tab.

On Wed, Feb 16, 2022 at 07:05 PM, Simon Brown wrote: Ham Radio Bandplan for SDR# - SZ1A Designed for SDR# but can be imported into SDR Console.Works very well. Thanks for the tip Simon. I've

Hi, Ham Radio Bandplan for SDR# - SZ1A Designed for SDR# but can be imported into SDR Console. Simon Brown, G4ELI https://www.sdr-radio.com -- - + - + - Please use

Opss ... I meant Ravi

I'm waiting on a response from Seri regarding mine

I found this thread two years later and all the images are missing. Would it be possible to resurrect them?

Record a 10Mhz chunk, then use Datafile Editor to pull out 1Mhz chunks. ================================ Need help with SDR Console? If you have a problem: Go to

Hi Mark. Thanks for the hint. I guess that is the full fledged Hermes board covering up to 55 MHz. I am not sure SDRC supports this breed of Hermes. I only found support for the HL2. 73 / Ingolf,

Ingolf, I'm not sure how close the HL2 board is to the Hermes 14 bit board but the Apache Labs factory is currently doing a limited production run of assembled and tested Hermes 14 bit

Hi, I wanted to start this today – cannot find my DUO microphones! Must be in the roof space, looked – nothing. Will sort out the roof storage over the weekend. Sorry for the delay. Simon

Hi all. I have been too late to notice the possibility to order for at least three runs of the HL2 at MakerFabs. I wonder if there is anyone out there that has bought a HL2 board but not yet

i do not know how simon handles 1x10 or 10x1 mhz chunks on recording (if it is lossless to split in 10 receivers or not) ,,, in principle these could be lossless ... it even should be

On Wed, Feb 16, 2022 at 06:35 AM, Simon Brown wrote: I’ll try to remember exactly what the idea was. This part of the code must be ~6 years old, certainly from the early days of V3 when I was

Fewer aliases right around the boundaries of adjacent recordings comes to mind. {o.o} On 20220215 16:03:00, Siegfried Jackstien wrote:

Hi, I’ll try to remember exactly what the idea was. This part of the code must be ~6 years old, certainly from the early days of V3 when I was learning a great deal very quickly. Simon

I've found my version no ground to USB and no way of knowing the modification as all information on the internet gone. An easy way is no BNC connected if there is noise earth usb and BNC and it

maybe cpu load is different keeping several recording running in parallel or one bigger (needs for sure a fast ssd and/or a hefty cpu)... same with analyzing them ... ... in fact i can not

On Sun, Feb 13, 2022 at 01:20 PM, michel soldevila wrote: Hi group, A very basic question, sorry: with SDR Console, I could record the I and Q signals over the full bandwidth of my RSP-2 SDR, i.e.

Thanks Sigi. But then why offer 9 bandwidths from 500kHz to 10 MHz, if the performances are the same? There is necessarily something that changes depending on the bandwidth, but what? 73, Michel

Hi, Standalone isn’t yet supported. It’s next on my list – my development DUO broke and I only just got it back from ELAD. Simon Brown, G4ELI https://www.sdr-radio.com