Oy! Hopefully all the problems are sort of past and you can enjoy the party. {O.O} Wow! On 20220723 19:56:58, Kriss Kliegle KA1GJU wrote:

As luck would have it, we were just arriving at Oshkosh when our daughter informed us of a multi-hour power outage. The servers didn’t get reinstated until late morning when the power returned.

With SDRC you don't. I'm in a state of interruption on working up a hack work around. {O_O} On 20220723 08:17:37, Dirk wrote:

On Sat, Jul 23, 2022 at 04:17 PM, Dirk wrote: How can I adjust/switch the RX-888 MKII's internal gain and attenuation stages and the Bias-T? In the settings dialogue I can of course choose bandwith/SR

Hi Simon, I installed the new SDRuno and the new API, I then ran console and deleted the SDR definitions, did a search for both my RSP2 and RSPdx, both were found so I added these new definitions and

I'm able to get a RSP2 working with SDR-Console 3.2 and the 3.10 API in a clean windows VM. I did not however install SDRuno but instead installed the beta 3.10 API. Hum...

Simon, do you need some more testing or did you figure out what is going on. I have my SDRduo with me and can help if needed. -- Dennis KA6FUB

Thanks Simon Brown https://g4eli.com https://sdr-radio.com

Dennis, BINGO!!! Thank you for your suggestion. You were correct, my radio uses COM3 and as soon as I switched it everything started working again as it should. I also switched rig type to TS-590

Bruce, I am not sure why you use a virtual COM port configuration. I have a TS-590S and my Omni-Rig setting uses the port of my radio. Based on what I see I think your radio might be connected to COM

My new RX-888 MKII was running without problems with SDRC from the beginning. The experience was quite impressive. What I couldn't find by now: How can I adjust/switch the RX-888 MKII's internal gain

Simon, As I said earlier, I had already stepped back to the V3.09 API. So to follow your instructions below I had to reload SDRuno 1.42 0720 with the V3.10 API. The only

OK, Please do the following: Start Console Search for the SDRplay radios Save the logfile Attach the logfile to this postIf the Search actually finds the radio, then attempt to start, if this fails

Simon, The SDRplay RSPduo works. The RSP2 does not work. Assuming the RSP2pro doesn't work since the only difference I'm aware of is the metal case. -- Mike

So, Please just let me know which SDRs work and which SDRs do not work for you with 3.0.10. I cannot find a RSP2, I don't think I've ever had one (am not sure). Please - I need an exact answer so I

I asked about this new "user mode" and Win10 SDRuno support had here was the latest reply. -------- Forwarded Message -------- Subject:

Simon, I've already stepped back to the V3.09 API. While running V3.10 API, it was my RSP2 that could not be found by Console. I need to walk back my statement on my RSPduo.

Mike, Please do the following: Start Console Search for the SDRplay radios Save the logfile Attach the logfile to this post If the Search actually finds the radio, then attempt to start, if this

Hi Manfred, Thank you for your note. The directions for setting up a Kenwood external radio say to use TS-2000 for the rig type. Best wishes, Bruce

Prefer to open by serial umber if that fails find first available and punt. {o.o} On 20220723 02:08:39, Simon Brown wrote: