Hi Tom, The Matrix can only see the extents of the radio receive bandwidth. The Matrix windows (you can select how the matrix grid is presented on-screen ... 1x2 grid, 2x5 grid, etc.) are useful

Simon, Are you going to support the Elan DUO? Thanks, Greg KN4APC

I have been a long time fan of Simon's work. I am still learning all the new features in V3 and recently did a YouTube show (my channel is hamrad88) on one of his new features. I have not used the

Hi, I didn’t know this board existed! I will not be adding support, sorry. Simon Brown, G4ELI http://sdr-radio.com

Dear Simon, Thank you for your clarification. I will continue my research and give you more details soon A stupid question about the dual short cable USB 3 + USB 2 supplied with the LimeSDR Do the

GM, I have finally got v2 to work with the CCW SDR4+. However, the displayed frequency is not the frequency I am listening to, it's out by a few kHz. The manual shows how the frequency can be

That is correct from what I found. The chip used on the board is an FPF3042 rated at 12.4v in Max. This is based on info from the LimeSDR schematics and BOM. I use 9 volts. Mike -- 73, Mike,

Bernard, It doesn’t ‘crash’, it stops running, a crash is different 😊 It doesn’t ‘crash’ immediately, it clearly runs for a second or so – you see some data in the waterfall! Did

I set the LNA gain to 32 and the VGA gain to 36 but the only change I noticed was a much stronger signal at 20MHz and a clearer 500 Hz tone. Rachel Carr

I have found that I need to set the LNA gain to 32 and the VGA gain to 36or so then I can see a 1296 beacon that comes in 40 db above the noise floor.I’m using a simple antenna that came with a GPS

I finally found some time and got SDR-radio working with my HackRF but I having trouble actually receiving something. The Broadcast FM comes in pretty clear. The best WWV signal I get is at 20MHz

Not a solution to your problem but just a note.... I am not sat by my Lime but seem to remeber reading somewhere that the max DC voltage was 12V. I may be wrong..... Paul

Dear Simon, SDR Console V3 64 bits build 696 With LimeSDR the software crashes immediately Short USB double cable supplied with LimeSDR + 13.8 volt supplementary power supply What to do? Best

Am 03.04.2017 um 14:41 schrieb 'Allan Isaacs' allan@... [sdr-radio-com]: ... fully ACK, Allan, just received Auckland VOLMET on long path with that combo over 22.000 km

Just like in the good old days when weused a 2m converter in front of an old communications receiver Nils. It might be worth thinking about designingsuch a thing as it would need only a tuned circuit

Allan - my experience is, that after the suggested mod you will get an acceptable HF performance only with an able up-converter (I am using the SpyVerter). The 30 MHz bandwidth is very

Now I have a fairly stable method of setting up and testing my Lime SDR I find no surprises. What doesn't show up in information that I've read is the practical effect of that steep falling off of

Hello, I have a PicoZed board and would like to run it using SDR-Radio. Can anyone help me? Regards, Sudip Kar

Hello- New to the Group and new to SDR Radio and using SDR Console V3. I am using an SDRPlay RSP2. - My question concerns antennas. I currently have connected to Ant A on the RSP2, my 160 M

David If it’s an Atom processor you can gauge how good it is by the entries at the bottom of the table… not so good. I use an Atom next to my TV for DVDs and playing avi and jpegs etc. at 1920 x