i did not try it with sdrconsole v3 ... but i did get it woking with hdsdr (sync my icom765 and my fcdpp) so the only thing i can say is ... it may work (depending what simon included

Sorry...the Youtube vid title is: SDR IC 7300 G4PNX

Hello All, Is there anyone out there (preferably in the UK) who has been able to link this lot together using Omnirig so that you get bidirectional control of the 7300 and FCDP+ Please see the

Squelch for AM, SSB, CW in v3 wants to infrequently open briefly for no reason that I can see on the waterfall. No noise impulses, etc. Sure, I could tighten the squelch more, but then I lose

Hi Jared, I'm probably the least qualified to answer your question, but I do see your noise floor jump way up across your entire receive bandwidth whenever the station you're listening to transmits,

I am having some trouble with SDR Console when receiving police on FM. I find that when they key up, my water fall produces many lines across the spectrum. these lines extend across 10 MHz if I zoom

Hi Thanks for your reply but I need to find out how to get rid of the yellow triangle from my listing then my radio will be available for others to use. Cliff

Hi Guys, A friend, Bob, has the following questions on setting up SDRC with CW Skimmer. I was wondering if anyone can assist him. Now that 6m E season should be on us I am sure there will be a lot of

I believe the Yellow triangle next to listing on Simon's site indicates that the link is NOT working. You need to try another site without a yellow triangle. Hope that helps...Cal,

Hi All I am having problems logging into status.sdrspace.com. this is what I see on the status.sdrspace.com/onair.xml. Cannot access 95.156.204.25 port 7999 . Location is Catral. Spain. Website

Hi All I have been trying for the last 24 hours to sort this out but cannot find out what going wrong this is what I see on status.SDRSpace.com/onair.xml. Cannot access 95.156.204.25 port 7999 .

Try starting your dongle, try to switch to AM or SSB then take� a screenshot and post that on here for us to take a look at. Make sure you have the recieve DSP pane showing.

I have been using preview 5 since it was released in early January with an RTL dongle radio and a noo elec upconverter. Everything works fine using FM modes. When I try to change mode to AM or SSB the

Thanks for the answer Simon. I now have a much better understanding of the "Memory Size" number displayed now and in future releases. I do consider increasing the RAM size but I will wait until I have

Hi, Note: in the next preview the memory usage has been reduced. This is virtual memory, essentially RAM The memory indicated is the maximum virtual process since the program started (in the

Hi all. At the lower right corner of the main window V3 reports a Memory Size. I would like to understand a little more about what that is and what numbers to expect. 1) Is it pure RAM or is video

Hi Joe Thanks for your reply and help I will try else I will have to wait for the update to come. Cliff

"Auto" only affects the brightness setting in the waterfall window. Von: sdr-radio-com@... [mailto:sdr-radio-com@...] Gesendet: Freitag, 14. April 2017 20:12 An: sdr-radio-com@... Betreff: Re: AW:

Now I found it. Its up in the ‘Extras’ on the ribbon. Click‘Zoom’. THanks...... Hubert

Now I see what ‘1’ is. Color is yellow and hard to see. But clicking‘Auto’ has now effect on my system. It used to work but no more. I haveuninstalled and installed – no help.