Hi Simon, The firmware in the ANAN 100D is version 11.6 from file Angelia_Protocol_2_v11.6.rbf. Attached is the logfile. Look at this when you can. 73, Carl Moreschi N4PY 58 Hogwood Rd Louisburg,

Perfect, Thanks Gaute I thought "update" was a button for on-line software updates. RB KM6LPW

Hi Carl, I will play with my SDRC ANAN tomorrow, my Sunday QRL wise as I work a day behind, and see if I can work out why I have had a simular problem with the really stable RTL. I reduced the BW of

Hi Carl, I don't have time for ANAN support now - in four weeks maybe. I have a lot to get done and must also design a new website for the ANAN support. * Logfile? * Version of the Protocol II you

Hi Simon, I now have an ANAN 100D. I flashed it with protocol 2. It is working fine with Thetis. But it only stays operational with SDRConsole for about 5 seconds and then SDRC quits operating

Hello, Looking for advise. Has anyone built the PennyWhistle Kit. This is a low power 16 to 20 Watt amplifier. The output stage is a single stage amplifier that uses a pair of TO-220 "16 Watt"

Great capture Simon

No I have not downloaded Thetis yet. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com

Not had that problem. It connected and ran on sdrc with no problems at all. all problems i had were due to the 100 hub i had conected. Did you get Thetis to run with your anan? Although the

Paul, You have been very helpful. It looks like my router does not support gigabit. I connected directly to my lan card and now SDRConsole discovers the radio. It connects but nothing

Are all of your cat5 connections/hubs/routers etc 1000's ? If you have any 100s in there you will not see your anan. If the answer to the above is yes then go back to the bootloader screen and

Well after loading the 100D protocol 2 file with HPSDRprogrammer, nothing can find my 100D now. Now what? Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com

I forgot the most important link..... http://sdr-radio.com/v3_preview_downloads Afterall the reason you are loading P2 is to run SDRC as your tx/rx with the ANAN. From: main@SDR-Radio.groups.io

Good information Paul, For the 100D you need to go up two levels and follow 100D

These may be what you are looking for. Please remember that I am a total idiot when it comes to computers so read well before you follow anything I

I now have an ANAN 100D. I downloaded the HPSDR Progammer. But where do I find the protocol 2 firmware to load in the 100D? I would very much like to run SDRConsole with my 100D. Carl Moreschi

Just received this using the Airspy R2 and NOAA-18. Going to be 'moist'. ☹ How? See http://sdr-satellites.com/Weather Simon Brown, G4ELI www.sdr-radio.com

Hi RB. Sorry for the somehow "round about" answer. As a member of the test team I love to mess around with the Console to better understand what works and what does not :-) Amazing what you can learn

Hi GL, I have build 811 so frequency editing must not be implemented yet. Thanks, I am thinking about your answer. sounds a bit round about but whatever works. So first create a new file for a new

Noise floor isn't the only consideration. Dynamic range is valuable when a weak signal is adjacent to a very strong signal, or when an extremely strong signal would otherwise simply overload a