jdow, you probably entered this conversation somewhere down the line. In earlier emails I did indicate that I HAD to run Zadig, because W11 decided it had just the right driver, which of

Just for the record; I am not by any means very savvy when it comes to computers and software, especially the intricacies of SDR.  On the other hand I do have a bit of experience and I am a dedicated

Dotting an i here - did you run Zadig on this system? Did you copy settings etc from the Windows 10 system? {^_^} On 20220731 18:04:09, Chris van Lint wrote:

I also noticed this, but dismissed it as the potential cause, because when starting SDR-C and clicking the <Definitions> followed by <search>, the program has no trouble finding

you also can cick in main spectrum (as an example to a new station that you see in waterfall) and when focus is in main spectrum you also can tune (i use arrow keys cause my laptot has a

Before going through all that, it is more likely that it is caused by a hidden device in the device manager. Windows is horrible with its handling of USB devices. On 7/31/2022 2:45

I picked up a Contour Multimedia Controller Express and using it with SDRC - I have programmed one of the buttons to be F5 for TX and it works well - I have programmed the shuttle to be mouse up/mouse

I pulled out my dongle and set it up to see how it works. No problem. The EEPROM error I would agree is a clue. Maybe a Zadig issue, wrong version, or used the wrong device name when the driver was

Sven, my recommendation to everyone having issues with SDR Play devices, specifically if the software has been upgraded, is to start fresh. Do the following: 1. Disconnect all SDR play receivers from

I see 3.10 is no longer a beta, it was 3.10 Beta 6. Simon Brown https://g4eli.com https://sdr-radio.com

When I installed SDRuno 1.42.0720 I had to use the 3.09API on my Win 8.1 laptop. When SDRuno 1.42.0728 was released, it re-installed V3.10API which was usable with no need for V3.09.

So, I believe the SDRuno kit was updated to use 3.09 - or users were told to install 3.09. If you have a problem using 3.0.9 or 3.0.10 please: Let me know exactly what models are connected to the

I have a couple of SDR Play SDR's: RSP1A and RSP2dx will be found by SDR Console 3.1 and 3.2 but not startable. My RSPduo and RS2PRO not discovered. Must use API 3.09 with SparkSDR and SDRuno to get

That's what I noticed - wondered about the exact dongle model. maybe a photo of the dongle? Simon Brown https://g4eli.com https://sdr-radio.com

Have this working, adding a refinement, test team kit today. Simon Brown https://g4eli.com https://sdr-radio.com

The EEPROM could not be read? Ah that suggests an installation issue of some sort. Without that determining much of anything about the dongle itself is impossible. {^_^}

Hi again Simon, I am not specifically interested in VHF. I have several analogue radios which will cover that, but SDR-C on my Laptop works brilliantly, so to be perfectly

Hi Simon, See attached Chris On 31/07/2022 06:42, Simon Brown wrote:

Yes, Much easier to read, thanks. One thing I notice - there's a signal at the centre frequency irrespective of the RTL's LO. Let's have a look at the Radio Configuration - button on the ribbon

Sorry Simon, Hope that this fixes that issue 73 VK4CVL -------- Forwarded Message -------- Subject: Re: