I'm playing with using the software as a basic spectrum analyser. Would it be possible to a add the facility to create a "reference spectrum" by saving the current window and then subtracting that

😊 I’ll make this more obvious. Simon Brown, G4ELI www.sdr-radio.com

Enclosed please find (via PayPal) a "Stupid" fine in the amount of $10 USD. I said I'd make another donation, should I, by some miracle, 😠😠😠😠 get SDRC V3 to work properly with

It was me transmitting on 80m, working ZL4RMF, ZL3RIK, ZL4UC etc. My 80m dipole is close to the RX antenna. Simon Brown, G4ELI www.sdr-radio.com

I agree, it looks like very broadband ( Utility based "spark transmitter" ) signal that crashed your SDR. Randall KM6LPW

Hasan, Very happy to hear you have it working. Normally the uploading occurs almost immediately. This morning is an exception, as the Fox Telemetry Server appears to be off-line. When

After fighting this for a week, this is the cure: Thanks to all of you and the last magic bullet from Terry, ZL2BAC. Setup: 2m EggBeater at 7', 80' 9913 coax AirSpy HF+, SDR-Console V3.03 FoxTelem

My email adress is : pd0sbc@... Cees, PD0SBC Op vr 5 okt. 2018 om 16:36 schreef Stephen Reed <g6xju@...>:

g6xju@...

Powerline noise (in the meaning of PowerLAN, Homeplug PLC...) does normally not appear on 80 m. The manufacturers have agreed to "notch" (reduce by 30 dB) their broadband signals inside the ham bands.

Hi, Me on 80m 😊 . Simon Brown, G4ELI www.sdr-radio.com

Until our local utility company did some tree pruning, I had the same thing here during windy rain events. Our power lines (3/10 mile to end of grid) are somewhere in the 9600 V range. They seemed to

Greetings: I was connected to G4ELI's server this morning and am wondering about the intermittent event I was hearing and seeing on the 75 meter band. The screenshot shows the intermittent signal

Simon, Hello, I would like to join the ANAN test group as well. I'm using the ANAN-10 and will install new protocol today. 73's de Cees PD0SBC Op do 4 okt. 2018 om 22:36 schreef

Ed, What is Omnirig connected to? You don’t give me all the info ☹. Please try the following: connect HRD to SDR Console, do not run any other programs at all. Just HRD and SDR Console,

Simon, Please don't spend much time on this on my account unless you think there is something to it. Unless somebody chimes in with a similar setup and issues it may just be something here. I don't

Com0com does the same thing as the Eltima software. Sluggish for a few seconds, then works. Do nothing for a few seconds and it temporarily gets sluggish again for a few seconds then works. Not sure

I had a bit more time to play with the Eltima software, SDR-Console and HRD. It's not application focus. It's time. I scroll to change a frequency on HRD and it's very sluggish for a few seconds

Simon, Omni-Rig to run WSJT-X and FT-8. That's all. It works fine. But isn't using a Virtual cable. It works great. Thanks, Ed WD4ED

On Thu, Oct 4, 2018 at 12:14 PM, Simon Brown wrote: I need an e-mail address so I can invite you.rz1zr(at)mail.ru