WE can but wish! The Elad S2 is probably the best compromise between bandwidth and performance, being 16 bit. Here, I find the SDR Plays struggle with overload on Band 2.

Hi, For < $200 you can have: high quality/narrow bandwidth, or good quality/wide bandwidth. I ask Youssef every day for HF+ with 20 MHz bandwidth. He just laughs 😃 ! Simon Brown,

Hi, Having different SDR receivers in the market and regarding FM DXing... Is there any opportunity to have an AirSpy HF+ with a wider spectrum for FM DX? The actual 768 Khz bandwidth is not very

i do not use headphones but active speakers ... and do not want the echo the pluto now is so stable that i just set the finetuning once ... and when the pluto is transceive ... it stays

Hi Sigi, Why do you use simplex and not full duplex with the Pluto ? When you start transmission (going form RX to TX) I also noticed a kind of “long hiss” until your modulation comes

Hi Willy, I’ve been writing Ham software since 2001, so getting used to it 😊 . https://www.dit-dit-dit.com/ Simon Brown, G4ELI www.sdr-radio.com

I'm new to this group, and SDR in general, although I've been into radio for 50+ years. Being an engineer and programmer, I am really in awe for the fortitude and time that Simon puts into SDR

Fred, As always – add screenshots. Makes it so much easier for me to see what you are doing ☹ . Simon Brown, G4ELI www.sdr-radio.com

Sigi, PLEASE respond to the post in the test team. PLEASE try the kit I posted there. ☹ . Simon Brown, G4ELI www.sdr-radio.com

i still need v mix ... a short first tx burst when switch from rx to tx... is surpressed if you set a short tx on time delay (then it does not get trough the pluto to pa) that test

Same gain setting is all scenarios.

When I first start the software and transmit CW (TX calibration "off", no TX offset) I see power output levels that I would expect. I'm transmitting at ~50MHz into a 30dB attenuator and then a 10 dB

Hi, I’ve been working on this problem today; someone who had bursting now has none! I plan to release 3.0.8 tomorrow. Simon Brown, G4ELI www.sdr-radio.com

Tested the VMIX work-a-round today and it works for me as well. vy73 Elmar

Carl, That makes more sense since you're make the adjustment with your control software. Thanks for clarifying. Paul, W9AC

No. I'm just saying how my software solves this as a suggestion to Simon. It's how to code this situation. Carl Moreschi N4PY 58 Hogwood Rd Louisburg, NC 27549 www.n4py.com

Carl, Perhaps you can reply with an example of your filter setting and I'll try that as an interim solution. Thanks! Paul

Paul, I've noted this issue, FWIW the CW filter is designed to be symmetric around the center frequency, so if the center frequency is 500Hz then the filter is OK up to 100Hz; above 1000Hz the logic

No. The filter is adjusted so that it goes from zero to the hi end but not centered on the signal. The normal thing would be for the filter to go below zero if it is centered on the signal but

Carl, But then doesn't the true frequency display shift by the amount of the offset? I suppose that's a temporary fix but certainly an annoyance. Paul, W9AC