These are fine for aluminium / diecast. Quite a few to choose from. Simon Brown, G4ELI https://www.sdr-radio.com

Well, I’ll be on 4m and 6m this summer – mainly 4m but 6m during the 6m contests. I also will be on 2m but 2021 wasn’t so good – only 5 days with decent E’s for SSB. Full legal+ on

Thank you so much for doing this. Something I have been wishing for a long time after using sdr# and kiwi deep

See the following: https://sdr-radio.groups.io/g/main/message/65720 73 Kriss KA1GJU

Actually thin. Maybe I need to take up coffee. {O,o} On 20220221 14:33:53, jdow wrote:

There is a mute setting. Overload usually means you are transmitting. This prevents feedback. In your case the antenna switch made sufficient signal level change that it looked like you

Er thick not think. Just got up. {O.O} On 20220221 05:10:24, Simon Brown wrote:

Perhaps designed for wood and not think alumin(i)um. {O.O} On 20220221 05:10:24, Simon Brown wrote:

I think that you are right to do this, I am going to do the same. I will run mine at 0dBm to match both my K3S and TS-890 transverter drive levels when using it with uwave transverters. Its other job

Thanks. Conrad

I use these:

Hi Simon, from my understanding is the USBpower sufficent. See attached files. Maybe I found the problem. If I was for example on 40m I have to move RF Gain to round about 18 to see the SSB signals.

Looking for someone to correspond with to help me set up my remote located RSPdx I access via SDR Console. The site is RX only with 8 circle RX array an run by a small I5 NUC pc. I cannot seem to

1650 KBJD Denver CO 15180km [9432 miles] Received in Botswana. A new best distance for me. Airspy HF+ Discovery, SDR Console V3, random wire with binocular balun. Special thanks to Alessandro G. and

USB power? Simon Brown, G4ELI https://www.sdr-radio.com

Simon, after a reboot the spectrum display is again not working. As i was starting the SW the display show something but was not on the right frequence. Tunning the TRX and the frequenz display was

Many thanks Simon, did the insatallion right now. Everything looks fine so far. Had an older version of SDRuno running an did the update to 3.1. Unfortunattly that crashes both software. I am

Won’t run – use Depends to check for DLLs. https://www.sdr-radio.com/depends Simon Brown, G4ELI https://www.sdr-radio.com

Super Station #3 (W7 32bit netbook) won't run any version later than 3.022 build 1836 due to some file missing. I've loaded every version of C++ to no avail. I tried using the "Load Simon's World Map

Yes, SDR Console is fine with 3.09, add a screenshot of Console. If you’re not getting any data reboot (just to be sure). SDR Console and SDRuno coexist without problem, but you can only run