With regard to V3.1. selecting the buttons on the ribbon bar ie Home, Support. Check for updates, has no effect. Also when selecting a memory does not take you to the correct frequency, for example,

HL2 Run not happening ☹ Simon Brown, G4ELI https://www.sdr-radio.com

Indeed. I do expect a replacement though, also there are other projects in the works for VHF / UHF / SHF. Simon Brown, G4ELI https://www.sdr-radio.com

So how do I disable the high-power SMA (RF2 ?) during receive so that I only use RF3 (the one you added)? Simon Brown, G4ELI https://www.sdr-radio.com

I do not know of any stand-alone digital hardware versions of the dual-antenna diversity function. The most likely reason is that you would need expensive A/D and D/A converters and a fast CPU to

The MFJ one is wonderful!!! Eliminated all the electric fence problems and other neighborhood noise. Jerry W3CDE

Also group Re hard to source parts..they are now obsolete.no factory is going to retool to make..no profit..no make.. End of hl2 is soon.. this means buy next batch.. Now will there be a hl3?? No

Hi Simon Is there not spare switching available on gateway firmware..that could be brought out to switching ant..sure there is. Other Simon

RF1 low power out is only present when PA is turned on in HL2 specific TX settings in SDRC. Leave plugged in to transverter. RF3 - There is no switching internal to HL. Needs switching externally or

What about switching? Simon Brown, G4ELI https://www.sdr-radio.com

On Sat, Sep 25, 2021 at 03:22 PM, Simon Brown wrote: That's fine - if I can modify the N2ADR board then that's excellent.No need to touch board. Just pick up on header between the main HL2 board and

And I have one other question: in the old HRD SatTrack software, I could use controls on screen to adjust the base transmit frequency up or down in the passband (see below). I don't see that in SDR

OK, here is a screenshot of JO97 pass. It's not that strong (it was lower elevation), but you can see my signal is not remaining fixed even though SDR Console is adjusting the frequency for doppler

Um, I had a fellow about oh 500 meters away who routinely ran a kW when I lived in Glendora Ca decades ago. I got a nice R-390A to use. His signal was large enough it took out the 2kHz

Has anyone done work in creating a stand-alone DSP hardware implementation of the outstanding dual-antenna diversity function in SDRuno with the RPSduo? The idea would be a digital DSP version of,

Hi, That's fine - if I can modify the N2ADR board then that's excellent. Simon Brown, G4ELI https://www.sdr-radio.com

On Sat, Sep 25, 2021 at 01:19 PM, Simon Brown wrote: Clock1 and Clock2 – I see it’s documented but will need to test. Shame there’s no way to use a separate antenna for RX, I do have a small

Simon Assuming you talking about hl2 rx only antenna..yes you can do..abit of modding to hl2 does this..( don’t remember what i did.though all info is on hl2 group.) now can one alter software to

Here's a funny story for readers. Ages ago I persuaded my next door neighbour to replace his mains ethernet adaptors and instead use a cable from his BT router through his loft to his TV located

Well, Clock1 and Clock2 – I see it’s documented but will need to test. Shame there’s no way to use a separate antenna for RX, I do have a small unit from DX Engineering I can use for this.