Hi, I noticed that 3.08 was not set to automatic startup. You’ll have to bring this up with the SDRplay folks, it’s their API. Simon Brown, G4ELI https://www.sdr-radio.com

Like this – see attachment. Simon Brown, G4ELI https://www.sdr-radio.com

I am sorry Joanne, but I can not find the setting you are referring to under "Tools", "Options". Can you please post a screenshot to ease the finding of this particular setting enabling one singe

I've just upgraded two PC's with SDRuno version 1.41 and now SDRC doesn't want to start my RSPDx unless I first start SDRuno. It appears that the problem is that the old API v3.07 loads at the startup

Hello, Had the same "problem". Take about the subfolders. They must be there ! 73

Tested also with RSP2 @10MHz bandwidth? I don't know what to think, but it's not caused by the PC or USB power supply which is still similar to your PC and with sdruno 4.1 it works perfectly. The same

open receiver pane ... can be set to any position there you see the signal centered (it is similar to if window but can be docked anywhere and set to fulle screen width) and as an

Joe, If you are not in the test team then you must join, I’ve just published a kit for you. SDR-Radio-TestTeam@groups.io | Home Simon Brown, G4ELI https://www.sdr-radio.com

I hear tell that some laptops do not supply full power to USB ports as a means of increasing battery life. It's a BIOS setting. A fully powered hub should be able to turn the trick,

Open the DSP Panel (where you have the frequency display, filters, modes, etc) and open the IF Display. Then put mouse cursor inside the small waterfall and use the scroll knob on mouse. Active

There isn't, in the main display. Best to use the Receiver Pane, which does keep the tuned frequency in the middle. ================================ Need help

Works fine with both my RSPdx and RSP 2 Suspect this may be a matter of not enough power in some PCs, I am using an Intel i7 11700K @ 3.600GHz and runs both versions without problem.

USB sufficiency perhaps? Power supply insufficiency? Just wondering. {o.o}

As Dale confirms, his RSPdx works too, so it seems like a strange problem with some drivers on the SDRplay RSP2 version? Have others user with RSP2 tried, in addition to those already announced?

Just FWIW working fine @ 10MHz with the RSPdx here. Simon Brown, G4ELI https://www.sdr-radio.com

I do not see any option to keep the Tuned Frequency in the middle of the panadpter. Could you be more specific. Joe N9VX

Simon, That sounds good to me. Thanks, Joe N9VX

Yes, I confirm, it starts normally but if I have 10MHz no audio is heard and I do not have the WF scrolling, the "SDR" does not start. If I change to any other, below 8MHz, the audio restarts and the

Odd, I am sure I have a RSP2 in the cupboard, will try it tomorrow. It shouldn’t really matter which RSP I use – the API is the same. Simon Brown, G4ELI https://www.sdr-radio.com

Simon, I have a RSP2 here so I tested at 8 and 10 Mhz bandwidth. I found the same as Frank. Did not see this before as I rarely run above 8Mhz. I have attached the log files for both bandwidths. I