Max What would you have liked me to say? “A little bit miffed” perhaps

Thanks Simon

I think "attacked" is a strong word. Just close down one ad usually, sometimes not even that. Could at worst be described as a minor irritation (IMHO of course). Max

Not aware of this as an option in SDRC. It seems mouse wheel can be reversed by editing the registry: https://www.alphr.com/mouse-is-going-the-wrong-direction-heres-how-to-invert/ What about using a

No, Spin the other way? Mouse wheel down = frequency down, similarly when scrolling a web page. How is this mouse ball thing with web pages? FWIW software only knows that the mouse wheel has

Does anyone have an answer for this question? Joe N9VX

Hi, Only from https://www.sdr-radio.com/download . The advertising keeps the software free, without adverts (and donations) SDR Console would not exist. Simon Brown,

Can any member advise a safe sit to download a copy of SDR Console software without being attacked by a load Driver and PDF update advertising sites Many Thanks Derek H

Gedas, With many SDRs the local oscillator is at the centre of the display. Depending on the exact SDR and mode tuning to the centre may have no effect, a slight effect or even ruin

Sure I did ! Against a 10 m, L-shaped wire antenna with a wideband 9:1 transformer, and a buried coaxial cable to the shack. From 0 to 2 MHz, the mini whip is far better. I have just finished

Um, why the obsession with this? Most front ends have a gain control on them. Some, such as rtlsdr dongles, have local AGCs. Hopefully those are left off where practical to

But I like the center. Gedas, W8BYA EN70JTGallery at http://w8bya.com (under repair)Light travels faster than sound....This is why some people appear bright until you hear them speak. On

In console also with agc on There are sliders also for auto agc Preset us 130 db... I had better results with turning it down a bit.. Say 60 or 65 db And try what slope setting you need Dg9bfc

I would try to AVOID centre... Dg9bfc sigi Am 17.09.2021 01:03 schrieb Max <radiomax@...>:

One man's disadvantage is another man's advantage. I make overnight recordings of the NDB band. Omnidirectional is perfect for this. If I use the loop, I eliminate signals in two directions. I have

Thanks Simon Yes, my environment was high noise, and in retrospect , I should have put a choke on the feedline. I also noticed that the LZ1AQ system when used in dipole mode was also a lot noisier

Another disadvantage of e probe/ short vertical etc is that they are omnidirectional..( rx 360 degrees, incase i spelt that wrong.) where as loops are not, which if say your power line is north of

I don't believe that this is an option, at the moment anyway. Seem to remember it was discussed recently but cannot the relevant post. Had a vague recollection that Simon said he would look at it

Thanks for the comments on this. So I'm gathering this: When I output audio from SDR Console and pass it to an app through Virtual Audio Cable, there are four places I can adjust settings to

Manmade noise is mainly E... Not sure I agree but I only have my house to go by. LEDs, CFLs switching supplies are mainly low voltage high current. Used to be that high voltage was common, but not so