Hallo Ernst I'm far away from my PC, but if I rememeber right there is a shortcut assign list somewhere in SDRC. This evening I'll give you some more infos. Though the combination should works without

Ah, yes, a bribe may help. And some household chokes at your home MAY do some good. On his home they might make his network more reliable for him. But, they are expensive. Always give him suggestions

Maybe suggest a wifi extender, or a mesh wifi system for his TV maybe as a gift ??? Chokes on your own mains wiring might also help. But stay supportive - and legal. Michael

My house must be pretty typical Kriss. I got rid of a specific bad mains plugpower supply and the MF bands quietened considerably but one day we had twopower cuts in quick succession causing my

Not USB for sure. It's a digital whazzit. {^_^}

Hello Andrea, you can try the following code-example: #include <Keyboard.h>void setup() { // make pin 2 an input and turn on the // pullup resistor so it goes high unless // connected to ground:

I had a quick look at the midi part of sdr-console last night. Would it make sense to have a tick box for command repeat? I'm thinking if a controller button is in the down position it could be used

Hello Andrea, I am not so familiar with SDR-Console. You wrote about zooming with the shortcut AltGr+Shift++/-. I just tried this with the real keyboard and nothing happens. Have I to configure

Frank, Always good to hear of a result. I wonder about heat? Anyway, 1% CPU load is acceptable 😊 – must be a nice CPU / GPU combination. Simon Brown, G4ELI https://www.sdr-radio.com

Following up on my earlier email regarding the problem I had with SDR Console stopping after about an hour of operation, I thought I would give you all an update. The problem was originally

17M band (CW portion) and 6 kHz wide:

I have a 1M loop with an amplifier(LZ1AQ design) and works amazingly well. Amplifier came from Everett, N4CY, who advertises here and the Airspy Groups.io site when he has built, tested amplifiers

Hallo Ernst I'll try too, thanks :0) Andrea

Hello Andrea, No, HRD dies mit Unterstand Midi until how. There I will use the keyboard. Zeus-Radio also can use Midi. I think with keyboard.h ist should be possible to send non-printable

James, do not invest in this antenna if you cannot mount it outside. I used it outdoors with very good results. But at my former QTH I had to try it indoors and it was useless there. In a noisy

The PA0RDT will have from my experience the same problem with picking up noise, I have so far only heard of the youloope antenna sold by airspy and rtlsdr shop, it does depend on you having a low

Hallo Ernst Thanks for the feedback and for the useful infos. I also tried the Arduino keyboard simulation as it gives more possibilities then the MIDI to USB interface (this is limited by the "few"

Hi All, Another newbie question.... I currently have an MLA30 mounted in a window away from as much interference as possible. I can't place it in an ideal location outside as I live in a pretty

Hi All.... your advice is much appreciated - I'll have a think about it but feel that putting some pennies away and investing in the Elad might be my best bet. Thankfully I'm in a relatively low

Hello James Well to be honest if you're contemplating looking at 20MHz or so of bandwidth then you really need to be looking at multiple monitors? And you'll most probably need a secondhand i5 or i7