Dear all, I have developed a custom VLF receiver. To capture the data I am using Keysight Data Acquisition Module which I am programming via C# to capture the data. I am sampling the data at 100kHz.

Hi Greg Just to let you know you are not alone! I’ve tried for ages to synchronise an IC7100 with an RSP2 (and others!) and SDRCv3 using Omnirig , no problem, BUT try adding a logging programme

Goodmorning, i'm writing a software that connect to a ham dx cluster and repeat spots while adding other useful spots based on a list. you can check it here:

Hello Simon, All if i’m understanding the idea, maybe there could be a ‘configuration save’ command or button to easily name, save, and recall a nicely tweaked operational setup and with a

Hi, I was thinking about this – I’ll keep this in mind. I do see a user for a more complete startup command set. Simon Brown, G4ELI https://www.sdr-radio.com

Thank you Simon. SDR-Console has SO MANY features it's good to know it's not there and I was missing it. Thank you, Bill

Have you tried the trick of runningup something like maybe google earth and letting it just sit there in the background? (It's magic....) {^_^}

Use the Broadcast FM filter, that's how! Try the filter labeled BFM, or add it to the list of choices if not there. 73 Kriss KA1GJU

Good morning, I am unable to set filters for WFM larger than 48 kHz. This does not permit to listen broader signals for FM broadcast stations. Attached a picture about the set window. What can I

Bill, Not been done, currently not planned. Simon Brown, G4ELI https://www.sdr-radio.com

Sigi, As seen in the attachment, the Resolution was set to Default, Waterfall Speed to 1, and Bandwidth to 500 KHz. Rebooted again, and still no change, with ~1 Sec delay in

I used fldigi with my Kenwood TS-590 for years, using rigcat for tracking via CP210x USB-UART Bridge (COM9). I now have an RSP-2 running with SDRC V3 and tracking my TS-590 external radio via OmniRig

something you could try ... close all not needed boxes (if display, spectrum view in rx and tx box etc ... ) lower waterfall speed lower resolution to default (maybe you have

Simon, Are there some configuration or log files that would show the differences between the desktop and the laptop, that would tell you how each is functioning? Perhaps there's

Hi Max, OK, here's a twist for you. Just for S&G's, I fired up SDR Uno (running the latest version 1.33), and it does NOT have the tuning lag seen in SDRC or HD-SDR using the

Hi, I would like to automate the playback of previously captured ELAD S2 wav files with SDR Console. For example I have a 1 hour capture of 92-98MHz and would like to playback 92.1 then after an hour

When upgrading firmware it is a good practice to use the vendor's recommended software, SDR# in this case, to verify operation and check versions before upgrading. If there is a problem this will

Thanks for the reply Simon. I am on R3.0.6 now so it looks like a very minor change that I was not sure I could interpret what it actually meant. Snipe R3.0.7 - 2020-06-04Optimized the USB data

Hi, Really it depends on the firmware you were using before. I was on 3.0.0 so some good improvements, not the least being the extra bandwidth. I have far too many SDRs, I use an Airspy

Thanks for the info Simon and Kriss. Pardon my ignorance, but what good does this FW upgrade (R3.0.7) do? Reading the Airspy change log ( https://airspy.com/downloads/hfplus_changelog.txt ) it looks