Hi Andrea, yes of course, but i wouldn't call it a PCB ;) Just a strip pcb meant for prototyping. The vertically arranged resistors are for limiting the LED current. The

Er, No – the NCO will just make sure you’re on the correct frequency, correcting for the LO offset. Now I also have a similar offset on RX which I can also correct. See you in the test

Pete, CW Drive level – noted, I’ll look into this tomorrow. I’ll also invite you to the test team. Simon Brown, G4ELI https://www.sdr-radio.com

Hi, https://www.sdr-radio.com/support#Screenshot “Attach an unedited, complete screenshot to a posting in the Groups.io user group.” Simon Brown, G4ELI https://www.sdr-radio.com

It's a good shout.. I've added to my signature.. if only to save me typing it every time someone posts with an issue: =================================== Need help with SDR

How about going to SDR-Radio.com and clicking on the big RED "?Help" And check out the TWO camera icons in the ribbon bar. Cal...W1HHO All the Best.From the woods of Maine.

There are some that do not include screenshot at all, but there seem to be a large number that don’t know or understand the difference between a photo inline vs. attached as a file. I suspect some

An F.A.Q. site Entry 1. AFSS "Attach a fine screen shot" Stu

I took a screen capture and then edited it. Look at receiver #4, I put a red dot that indicates this receiver is un-squelched. This is what I had in mind. I guess another option would be to change the

I'm happy to report satisfaction with the keying improvements in the above-referenced version of SDRC on my HL2 build 9 The sidetone operates with minimal delay through a USB interface - I have a

I just did a search through everywhere I could think of on this forum and nowhere could I find the actual instructions for correctly adding a screenshot to a message, except occasionally within a

Thanks, Simon Will the NCO be used to correct the frequency display so you don't get the impression it is tracking continuously when it isn't, or to allow the Lime to achieve smaller 'steps'?

OK, What you see and what’s shown confirms the way the Lime chip works. I’ll add correction for the offset shown in the panel by adding an NCO. I’ll invite you now to the test team, with

Hi Simon Tested again Lime running at 144 transverted to 2400MHz, and the Lime running directly at 2400. Signal was a slowly changing frequency input from WSJT-X as before. Results were the same as

Hallo Chris, May I ask you to show us, when you have spare time, a schematic of your arduino micro knob or at least a photo of the back of PCBs? Thank you very much :-) Brgs Andrea SWL I-1360TN

Bill, If you don't feel comfortable doing the expanded frequency and dual Processor mod for the Pluto just download the Satsagen spectrum analyzer/tracking generator software and when you install the

El viernes, 8 de mayo de 2020 22:14:22 GMT-5, albert oax <albertoaxmx@...> escribió: Dear Simon, I have a question which application

Thanks Chris and I really appreciate your help. Bill - G4ERV

Here’s how I fixed it on both of my systems that were stuttering: Start SDRC and ignore the stuttering for now Control-Alt-Delete Select Task Manager Click on the details tab (you may have to

Simon, just reading through your instructions at https://www.sdr-radio.com/rtl-dongles and looks like a typo. Where you say USB it should read TCP, see attached screenshot. BTW that statement