Hi Gang Did anyone find a solution for this issue? I lost my markers some time ago and can't get the back. Some screenshots for your entertainment:

I have an i7 3.4Ghz with an Nvidia GPU and 16Gb of ram and it locks/stutters/lags when I'm running 2 VFOs, VAC, WSJT-X and GridTracker. It's not my power settings, it's not thermal throttling, it's

Nick, have you reinstalled the API (SDRplay_RSP_API-Windows-3.06.exe) or the ExtIO (SDRplay_ExtIO_RSPdx_Installer_1.0.exe). I have had zero problems now that I am now using a faster pc

Can SDRConsole pause sound recording with squelch triggers and start then again.

Just a shot in the dark, but have you checked your Power settings under Windows Settings? Screen Save to NEVER (Mine set to 5 minutes and not a issue with freeze ups) Sleep Mode to NEVER while plugged

Hi all I have an issue with the SDR V3 changing frequencies . This morning NOAA it was decoding NOAA 18 perfectly using WXTOIMG. After a while NOAA 19 made an appearance and the program insisted

Hi, try to slide on the very bottom of the waterfall the "span"-window to left or right: SDRC should then lock to the new ppm corrected value. Best Regards, Mark, DB1BMN

Hello, I have been having problems with this fantastic software doing a stand still or "freezing up" after about 3 or 4 minutes of inactiviity in the program. This has been happening for some time,

:( Thanks for the reply.

NP Jose. When I get a little time again I will do that and report back my findings. 73 Max

Hi Joanne. Yes, it stupidly did not initially occur to me to do that but of course, another instance of SDRC and my RSP has solved that issue and works well as a monitor. Can also record it for

Not supported: https://www.sdr-radio.com/transmit {^_^}

Hi, I am new to SDR's and recently had downloaded SDR Console to use it with Bladerf2. I have the RX capabilities working but not TX, I can see the TX DSP frequencies but the TX buttons are not

Yes, Max. Your 5w amplifier may output 5w saturated power, only good for a non-linear amplification mode like FM. Maybe only 2 or 3w watts for SSB working as a final amplifier with IMD products more

Yes, I have read this, but there's nothing that would describe a problem like mine. As you can see in my sample, I have a receiver with 100% volume and not muted. I can hear the sound normally while

It set me off destroying the sense of humor that might be in the message when I noticed how many groups to which he posted that. It switched humor into spam and a real attempt to prey on people. I

If you have a Hermes Lite 2 and another HF SDR front end such as an AirSpy HF+ (Discovery) you can stick a small stub of thin wire into its HF input (only input on Discovery) and tune to the Tx

Um, er, ah perhaps if you described your setup a little better some suggestions could be made. If your AirSpy is GPS locked then changing ppm won't do a fiddling thing, one hopes. If you have an error

Hi Wojciech Did you check the all the info here? https://www.sdr-radio.com/RecAndPlayback#Video 73 Max

Hi, The beacon signal *must* have the same format as the NB transponder beacon. The frequency you want to use is not supported by the software. Simon Brown, G4ELI https://www.sdr-radio.com