From: goscickiw This is a request for SDR Console, not for other software. I use other software as well, where I find it appropriate. I use SDR Console, because it can have up to 24 software

This is a request for SDR Console, not for other software. I use other software as well, where I find it appropriate. I use SDR Console, because it can have up to 24 software receivers/VFOs - I always

Hi George, Yes it includes virtual cables, but they are fixed to some channel strips… For full routing I guess you still need VB-CABLE or VAC. EA4GQY - Nicolas

Hi, I have been asked for this - I know how to add it, I'll probably add this once 3.1 is released but may add as part of 3.0.23, I plan to release 3.0.22 later this week. I plan a small interface

That’s a house for sale. Simon Brown, G4ELI https://www.sdr-radio.com

Lovely corner... What about the red arrow? Cheers J -- Jorge Garzón. EB7EFA / EA1036 SWL QTH 43°15'N - 03°56'W / IN83ag • Cantabria (España-Spain) Blog: http://jotagarzon.home.blog Twitter:

Sdr console already does this. Switch it to multiple receivers. I use 2 virtual sound cards to feed 2 different decoders. Thanks Steve m0zeh

Interesting. You mention any virtual audio cable. Does that include VAC as well as VB Cable? Regards, George, NJ3H

There is a squelch in Linrad that is based on an FFT analysis of the baseband. It works in all modes, AM, FM, SSB and CW. It would open the squelch at very low levels and the user can set a delay to

I wonder how it handles slightly different clock rates without ticks. Resampling takes a fair amount of processing power. {o.o}

Now that is a mind blowing software system. I watch both videos Dam. Allen Higgins KE8KZO

I use VOICEMEETER (8 inputs / 8 buses / 8 outputs mixing console) You can send any virtual audio cable to any other virtual audio cable or physical output, change level, eq, etc…

i have another option :-) i use dsp-filter (from makito mori ... look for mmana, mmsstv, mmtty ... and you should also find its audio dsp software) that takes the audio (in my case from

in tx box we have the "monitor" if clicking on "rx" would send the received signal to the speakers that would work (but it routes mic signal to speaker while receiving) tx monitor

Hi, My house is in the centre with a [ ] around it. Nice HF take-off… Simon Brown, G4ELI https://www.sdr-radio.com

Joanne...... Multiple outputs from one receiver. This would then remove the need for separate external techniques to monitor the output of the VAC etc, because one output could go to speaker, one to

Thanks for reading ma question and proposing diffent solutions. I use only one receiver on qo100 - (plus the default one for the beacon) Seems the easiest way ist to try the "listen to ..device"

a subsequent messages made it clearer. Windows does not really make this possible in a clean manner. Contemplate what slightly different audio sample rates might mean for two different outputs on one

Full size screen shot picture? {^_^}

I am not sure what you mean here Max. You can already select separate audio outputs for each receiver, if you have enough audio output devices to which it can be routed. Those are what you setup with