Greetings, Any thoughts as to what might be causing the interference around 7322 khz? Just hearing a hum. Regards, George, NJ3H Redmond, Oregon USA

Actually I am switching the software program between the native Elad S2 software and the Console program. I close out of one and open the other. There is a significant difference in signal strength

I think the issue is, when on USB or LSB, the filter section fails to show the variable bandwidth button. At least my screen does not show it. set it in AM mode for example and go to SSB and it does

How do you switch the signal between each radio? Thanks Steve m0zeh

Hello Siegfried, Spot on. I must have had the feature turned off when I tried it. I did notice CW doesn't have this implemented. That won't bother me at all. Have a great day! Regards, George

youre welcome :-) glad if i could help with pointing your nose in the right direction donations welcome (just a joke ... grin) greetz sigi dg9bfc Am 24.10.2019 um 03:07

Thanks for the clue. I am using a Perseus and an Elad. It was the Elad that I was having this issue with. The bandwidth I selected by mistake was 300+ KHz. Upping that to 6 megs amde all the

hmmm what radio?? what bw can your sdr deliver to console?? if you (as an example) use a funcube dongel pro plus ... it only has 192 kc bw (so no wonder you only see one station)

Am 24.10.2019 um 01:43 schrieb George Stein - NJ3H via Groups.Io: we already have it if you move the mouse arrow in the if specrtrum window ... over left or right edge of the

The zoom slider is set at the bottom. Sliding it up sends the x-axis in the wrong direction.

I would like to thank Simon for incorporating this feature into version 3.15 for AM and BFM and some other. It is essential in many cases, especially on the broadcast band. Of course, it is needed

zoom slider ?? dg9bfc sigi Am 24.10.2019 um 01:38 schrieb George Stein - NJ3H via Groups.Io:

It has been a while since I have used Console. I cannot remember how to change the frequency range displayed on the x-axis. On FM it is displaying just one stations width.How does one change so that

Greetings, I notice that using my Elad S2 software, while on a specific station, the S-meter reads S9+5, but when using SDR Console v3.15 listening to the same station the S-meter only reads S7. The

But, This is just SSB squelch, nothing more. Simon Brown, G4ELI https://www.sdr-radio.com

HF RX is not the issue. SDR-Console receives HF just fine. On par with my Ten Tec, Icoms & a Kenwood. No NCO math or anything. It also puts out signal on HF. It just is not usable to TX on HF. I am

Sounds great Simon - glad I started this thread now as I have been looking for a solution for many years!

I dont think it has anything to do with Simon.... I can Rx Hf ( sdrangel) with a 10Meg sample rate, hardware decimation at 8 and use the hardware NCO set to -28mhz (more to get 160m) then dial in a

I have the BPFs implemented well. If you look at my transceiver setups above, you will understand that it is all ready to go. BPFs, PAs, LPFs & the such. HF receive works great. I do specifically

oh yes ... set to 7megs ... receive 3rd overtone (21 megs) ... but also 105 megs (5 times 3rd overtone) ??? so for hf good filters .... very good filters ... are needed (same when you