Hi Simon, Updated yesterday from version SDR-Console 3.0.3 to 3.0.7. I ‘am using a RSP1A on my W10 system. I noticed that I have to put the squelch level up to around 90 in NFM to get it

Graham, I am not 100% sure what the problem is and the correct solution. Can you explain it in simple terms please? Simon Brown, G4ELI www.sdr-radio.com

Ideally the flip mode would be user enabled/disabled independent of the end point setting. Other programs like MacDoppler (earlier version) automatically initiated flip when the elevation rotor

Tony, Could be done but not really essential I think. Simon Brown, G4ELI www.sdr-radio.com

I was thinking along the line of 'adaptive' code. As you gain information about what the users radio is actually producing for a sample rate, save the information and use it the next time you start.

Thank you Simon! It will be a valuable enhancement for many satellite operators 73 Graham

OK, I am thinking about this now. If I can get a few hours of peace & quiet I’ll see what I can do. I will need the user to define the end stop – usually 180 or 360 degrees. Of course, it

Alex, Good point _ will look at this tomorrow. Simon Brown, G4ELI www.sdr-radio.com

Tony, Yes – but it takes time to get accurate values. Dave’s values agree with mine so I’ll update Perseus today or tomorrow. Simon Brown, G4ELI www.sdr-radio.com

Dave, Your figures are very close to mine, thanks. Simon Brown, G4ELI www.sdr-radio.com

Jugo, Just add screenshots of any part of the program when it’s not working. Screenshots show me what you are doing. Simon Brown, G4ELI www.sdr-radio.com

If you can look at the log file numbers over time and figure out what the sample rate really is, it seems like the code could do it too... Tony From: main@SDR-Radio.groups.io

The 125kHz data is now in the Excel file. It turned out to be the most accurate one of all - just 0.28Hz error! Regards, Dave On

In addition: The Pluto is not "hacked" (yet) and firmware updated to V0.3. Jugo, PA1AIS

Dear Simon, Do you want a screenshot from the analyser or SDRconsole? Any special menu or setting? Jugo, PA1AIS

Hi, i dont know if i messed the last post up so i´ll just trying again.. Console is working great with my RTL SDR and LNB with the usual 9750MHz LO. Now i wanted to set everything up as a server,

Simon, My data file attached. Out of curiosity I also recorded the sample rates at 2M, 500k and 250k, which revealed that 250kHz is easily the most accurate, and 95k by far the least. For the sake of

SCREENSHOT ! Simon Brown, G4ELI www.sdr-radio.com

First I want thank Simon for the excellent piece of software you made, especially for EShail and LNB freq. lock. I enjoy it every day since he published it. Last week I purchased a PlutoSDR and tried

Il 22/04/2019 16:53, Simon Brown ha scritto: