OK, Added to my list. Simon Brown, G4ELI www.sdr-radio.com

Dave, Post a screenshot – this helps me immediately see what the problem is, and also whether it’s a user misunderstanding. I think 48kHz doesn’t work well – not sure, but I removed it

Hello Simon, thanks for pointing me to the manual frequency input. Now I have a fixed setting I can go back to, if I accidently change the center frequency with the mouse. Frequency: 10489.540 MHz

Simon, Thanks for the quick response. I think the decision to use ‘flip’ mode and do the transformations of already-calculated AZ and EL bearings need to be done in the tracking software, not

Hi Simon, There appears to be a tuning problem with certain bandwidths on the Perseus, whereby the tuned frequency changes as the waterfall is moved from side to side, either by right-clicking or by

Thank you Simon, i tuned to ~10.5ghz but there were no signals and everything still present at 739mhz. The geostationary beacon window didnt work either as it didnt see the signal at 10ghz. Beacon was

Hello Alan, I made several changes... Same problem, but far less, RFI starts, base levels drop only a bit now. I lowered the LNA to 0, and increased the gain to 59 to get the signal to S7 on the

Alex, Just enter the 10 GHz frequency you want to use. As TX is greyed out you should be able to ignore that step. Post a screenshot so we can see how far you are… Simon Brown,

Good afternoon! i tried to set sdr console up show the correct frequency (10ghz) instead of the IF at 739mhz. Followed the instructions on the website but it says go to tx options and sync tx/rx. Now

Rick, No. The interface with rotator programs uses DDE, it’s really an issue for the rotator controller I think. Simon Brown, G4ELI www.sdr-radio.com

Hi, 1) You should not be able to open the CW Decoder window 2) I have no idea why the Digital decoder is not working I have logged this error. Simon Brown, G4ELI www.sdr-radio.com

Max, I will try to look at the Ettus code soon. Simon Brown, G4ELI www.sdr-radio.com

OK, Briefly: to adjust the bandwidth without changing the center frequency click here: And enter the Center frequency and Bandwidth. At the moment you must enter both Frequency and

Hi, This is a problem I am working on. I am 99% sure it's a driver issue. Simon Brown, G4ELI www.sdr-radio.com

I can't find where I can switch the software to simplex on my PC but on my laptop it is in simplex mode by default after installation and as I said there I do have the exact same result. Of course I

try it with simplex (do receive the tx signal with a normal rig or with another sdr setup like an rtl dongle or whatever) when you have short breaks in full duplex ... try it with simplex sometimes

Keeping up with the Jones? Soon everyone will want parity.

I tried SDR Radio for a while now every now and then but from the first time on I do have the same problem: When transmitting the audio gets interrupted about two times a second. Or should I say there

I now seem to have it transmitting ..though I have yet to test it on a local receiver!----Original message----From : simon@... Date : 21/04/2019 - 22:45 (BST) To : main@SDR-Radio.groups.io Subject :

Ah, Thanks. For obvious reasons I don't sign in very often - always signed in, bit like the Hotel California. Simon Brown, G4ELI www.sdr-radio.com