What I have been waiting for is a portable battery powered all-in-one SDR / computer / display. I could of course cobble one together from my Dell 8" Windows tablet, OTG USB / power splitter and an

LOL .... it is called SDRPlay RSP2...no reason to wait :-)

The SDR-4+ Special Edition brings all the changes together in one high performance SDR receiver combining a high IP3 push pull RF amplifier and switching mixer with improved RF filtering and a new low

Andrew, Were it an incompatible DLL then I would expect a different error. It’s not .NET related – I don’t use .NET, also this isn’t a driver issue as we’re not using special drivers at

Thanks, It can be improved when I have time. Simon Brown, G4ELI www.sdr-radio.com

Attached is a screen capture showing the NDB band. On the left side of the waterfall is a heavy BUZZ pattern caused by a street light near my antenna. Switching on the wideband DSP noie blanker

I think this processor is a SkyLake type so it may bea graphics problem Cal? I think USB3 problems started with later versions. Andrew…. Try running dxdiag.exe which might showsomething? Allan

Do I recall someone had an issue using a USB 3.0 port? I think they went to a USB 2.0 port and reloaded the driver and all was well. Just a guess. FWIW...Cal, W1HHO All the

Hi Andrew, FWIW, did you download the install files from here?: https://sdr-radio.groups.io/g/main/message/35571 That is the latest "clean" SDR-Console preview. LB6YD Gaute

Thanks, unfortunately no change when installed as an admin. Exactly the same result. The install works fine, but the program wont start.

Install as administrator if you didn't already

Hi, I just bought an SDRPlay RSP-2. SDRuno works fine as do all the other SDR programs I have (cuSDR, PowerSDR mRX, SDR#). But SDR Console will not run. I get a "The application was unable

Thank you Simon, and thank you Gaute. Best regards, Mark KF5VQY

Try using WFM mode into VAC Vincent

Hi! Have a problem with SDR Console v.3 with decoding DMR using DSDplus. For some reason decoding not works after i select sound output to Virtual audio cable. DSDplus receives sound well. Also works

Mark, I think I fixed this a few weeks ago, possibly not in a published kit – I forget ☹ . Simon Brown, G4ELI www.sdr-radio.com

Well, believe it or not, I did read your posting. And I did observe the same as you are describing. There are all levels of knowledge in the group so often one have to mention the most obvious

I forgot to mention, there is no difference between LSB and USB. They both exhibit the same behavior. -- Mark KF5VQY

Hi Gaute, I am observing the filter bandwidth while dragging the edges, but that's not really related to the problem I'm seeing. Please re-read my post. The opposite edge of the filter moves while

Hi Mark, observe the filter settings while dragging left vs right filter edges both in Main Window and Receiver Pane. See screenshot. Also test LSB vs USB to see what happens. It is a little confusing