RDS decoding in Console is very good but always check reception a few times from recordings, I've lost count of the times I've played back a short section of reception and the PI code has popped up only once in 3 or 4 loops of the same recording. This has been observed not only on Console but Sharp too so it's always a good idea to replay the same bit of reception a few times in case you get lucky.

I'd also suggest running RDS Spy in conjunction with the VAC output because that will grab PIs when Console doesn't. Asymmetric filtering is another critical component to RDS decoding if there's QRM to one side of the wanted signal.

One other trick that very occasionally causes a PI to pop up is to quickly switch between preset bandwidths like 150, 175 and 192kHz.

Paul
G7PUV
G9PUV

RX-888 MKII, Elad FDM-S3, RTLSDR820.
Icom ICR8500, SDRPlay RSP1A, A*rspy.
HS Publications D100 TV-DX receiver.
Sony XDR F1, TEF6686 tuner, XDR-GTK.
LNA4ALL, SV1AFN & CCW Multicouplers.
W4KMA 18-100MHz custom Log Periodic.
Wellbrook ALA1530AL1 active HF loop.
Korner 19ele BII, Korner 19ele BIII.

www.youtube.com/Aceblaggard

24 hour digimode log
https://bit.ly/3xxUQA2