Re: RSP TCP Server #rsp1a


Glenn Blum
 

How do I download and install using command line?

 

Sent from Mail for Windows 10

 

From: martin m3ghe
Sent: Friday, July 3, 2020 1:57 PM
To: main@SDR-Radio.groups.io
Subject: Re: [SDR-Radio] RSP TCP Server #rsp1a

 

59 isn't Maximum gain, it is Maximum Gain reduction or minimum Gain. You can use A20 to A59, A20 being least gain reduction.

Oh blast! I have just remembered I am using a modified RSP_TCP by Bas ON5HB, the commands are different from the standard SDRplay one. It is a available here https://github.com/ON5HB/rsp_tcp 
It will give you these controls
        -a Listen address (default: 127.0.0.1)

-p Listen port (default: 1234)

-d RSP device to use (default: 1, first found)

-P Antenna Port select* (0/1/2, default: 0, Port A)

-r Gain reduction (default: 34  / values 20-59)

-L Low Noise Amplifier (default: 2 / values 0-9)

-T Bias-T enable* (default: disabled)

-D DAB Notch disable* (default: enabled)

-B Broadcast Notch disable* (default: enabled)

-R Refclk output enable* (default: disabled)

-f frequency to tune to [Hz] - If freq set centerfreq and progfreq is ignored!!

-s samplerate in [Hz] - If sample rate is set it will be ignored from client!!

-W wideband disable* (default: enabled)

-A Auto Gain Control Setpoint (default: -34 / values 0 to -60)

-G Auto Gain Control Loop-speed in Hz (default: 5 / values 0/5/50/100)

-n Max number of linked list buffers to keep (default: 512)

-b Bits used for conversion to 8bit (default:14.5 / values 12/12.5/13/13.5/14/14.5/15.5/16)

-o Use decimate can give high CPU load (default: minimal-programmed / values 2/4/8/16/32 / 1 = auto-best)

-v Verbose output (debug) enable (default: disabled)

The original command set is, 
 [-a listen address (default: 127.0.0.1)]
[-p listen port (default: 1234)]
[-d RSP device to use (default: 1, first found)]
[-P Antenna Port select* (0/1/2, default: 0, Port A)]
[-T Bias-T enable* (default: disabled)]
[-R Refclk output enable* (default: disabled)]
[-f frequency to tune to [Hz]]
[-s samplerate in Hz (default: 2048000 Hz)]
[-n max number of linked list buffers to keep (default: 500)]
[-v Verbose output (debug) enable (default: disabled)]
[-E RSP extended mode enable (default: rtl_tcp compatible mode)]
[-A AM notch enable (default: disabled)]
[-B Broadcast notch enable (default: disabled)]
[-D DAB notch enable (default: disabled)]
[-F RF notch enable (default: disabled)]
[-b Sample bit-depth (8/16 default: 8)]

 

--
Martin m3ghe

 

Join main@SDR-Radio.groups.io to automatically receive all group messages.