1. SDR-Radio | Main
  2. Messages

Re: Strange behavior after running calibrate

Carl Moreschi <n4py3@...>
 

Hi Simon,

Here's a screen shot that just happened. Actually calibrate was not needed. I send 14.200 from my program and SDRConsole went here fine. I then clicked my band button for 18 khz, and all was fine. I then clicked my band button for 21.221 mhz and got the attached screen shot. So apparently SDFRplay went to 21.221 for RX 1 and the display is still showing 18 mhz.

Thanks for looking into this.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 11/11/2017 5:02 PM, Simon Brown wrote:
Carl,

Can you explain this with screenshots please?

Simon Brown, G4ELI

www.dxgalaxy.com
www.sdr-radio.com
www.sdr-satellites.com


-----Original Message-----
From: main@SDR-Radio.groups.io [mailto:main@SDR-Radio.groups.io] On Behalf
Of Carl Moreschi
Sent: 11 November 2017 20:13
To: main@SDR-Radio.groups.io
Subject: [SDR-Radio] Strange behavior after running calibrate

Hi Simon,

My SDRplay was a little off frequency so I pulled up the calibrate screen.
All worked well.

However, after running calibrate, the displayed panadapter and waterfall for
receiver 1 would not follow what band I was on. I could switch to a
different band and the receiver was working there but the display was still
centered on the previous band.

It looks like some setting is not cleared after a calibrate. I exited and
restarted and all was well.

Thanks and 73,

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 11/11/2017 2:29 PM, Ray Lyford wrote:
Be sure to have all the DSP Filters off.


What RTTY are you trying to decode.


Have you tried any other software. MultiPSK or Ham Radio Deluxe. They
both work very well. Multipsk is free for amateur modes and DWD rtty.


I use Multipsk a lot. It takes a little while to get used to it but it
works very well.



Regards Ray.





----------------------------------------------------------------------
--
*From:* main@SDR-Radio.groups.io<main@SDR-Radio.groups.io> on behalf
of n0kk@...<n0kk@...>
*Sent:* 11 November 2017 18:36
*To:* main@SDR-Radio.groups.io
*Subject:* [SDR-Radio] SDRc V3 and MMTTY Attempting to get MMTTY to
decode via SDRC.

Using VAC1 to route audio to MMTTY..Check..

But MMTTY not decoding..I assume Ive got a mode wrong or something..

Can anyone shed light on this?

Kirk, N0KK
Join main@SDR-Radio.groups.io to automatically receive all group messages.